Special week on SolidWorks Simulation tips!

During the hole week, we will be sharing with you one tip per day on how design validation can help you improve the quality of your design.

You will learn about planning your analysis, recommendations when using SolidWorks Simulations, some practices on how to obtain results with good accuracy and finally an introduction to Geostar.

Check out the agenda below and see you tomorrow for the first SolidWorks Simulation Video Tip!

Challenge your knowledge on 6 common design problems, take our QUIZ on simulation.

Mouse over to the top left corner to watch in full screen mode. More SolidWorks video tips? Check out our SolidWorks Learning Center.